

		     PATTERN SEARCH Command

	The PATTERN SEARCH command is used to find all the occurrences
of a byte, word, or long word in a block of M68332 memory.

	Upon invocation, this command requests a starting and ending
address for the block of memory to be searched. You must enter a
valid hex-decimal number to both requests. Further, the ending
address must be numerically larger than the beginning address. You
are next asked for the pattern that constitutes the search key.
This must be a valid hex-decimal number of byte, word, or long word
size. The block of memory is then read and each byte, word, or long
word is compared to the search key. Each match causes the memory
address at which the match was found to be displayed.

%END

